MythWatch is an Android Wear smartwatch app that provides a basic remote control for a MythFrontEnd. You'll need an Android Wear smartwatch. It currently only provides 9 fixed buttons.

It uses the http based Service api. Unlike other remote controls it sends commands rather then keys, so its commands can't be configured with the key bindings. It complements other, more complete remote controls, like mythmote.

Here is the layout of the commands:

Escape | Up | Commercial Skip

Seek Back | Enter | Seek Forward

Information | Down | Pause

Setup

You must have enabled the Network Remote Control Interface in the MythFrontEnd General settings and then open the MythWatch app on your phone as set the IP address or hostname of your MythFrontEnd.

Because it uses the Services API the port address must be one higher then the Network Remote Control port in the MythFrontEnd settings. If you don't change the port on the MythFrontEnd settings, you don't have to change it in the MythWatch settings.

Development

This was written, complied and debugged on an LG G3 smartphone using AIDE and DroidEdit and an LG G Smartwatch.

This was orginally called MythWear, but shortly after I first made it available I discovered there was a MythTV Android Wear remote control in the Play Store already and it was also called MythWear. So I changed the name to MythWatch, although the underlying name is still net.homeip.doconnor.mythwear.

MythWatch是Android Wear的SmartWatch的应用程序，提供了基本的遥控器，MythFrontEnd。你需要一个Android Wear的SmartWatch。目前，它仅提供了9个固定的按钮。

它采用了基于HTTP服务的API。不像其他的遥控器发送的命令而不是钥匙，所以它的命令不能用键绑定配置。它补充其他的，更完整的远程控制，如mythmote。

下面是命令的布局：

逃脱|最多|商业跳过

寻求返回|输入|快进

信息|下载|暂停

设定

您必须启用网络远程控制接口的MythFrontEnd常规设置，然后打开手机上的应用程序MythWatch作为设置MythFrontEnd的IP地址或主机名。

因为它使用服务API端口地址必须是更高然后在MythFrontEnd设置网络远程控制端口。如果不改变对MythFrontEnd设置的端口，您不必在MythWatch设置更改。

发展

这是书面的，遵守和调试使用AIDE和DroidEdit和LG摹的SmartWatch的LG G3智能手机。

这被称为orginally MythWear，但不久后我第一次做它用，我发现有一个MythTV的安卓穿遥控器Play商店已经和它也被称为MythWear。所以我改名为MythWatch，虽然底层的名字仍然net.homeip.doconnor.mythwear。