Sleek and minimalist watch face for Android Wear. Represents hour and minute pointers as arcs of varying lengths. Long press the watch face and click the little gear icon at the bottom to configure watch face colors and toggle 12 / 24 hour mode.
The watch face supports both burn-in protection and low-bit mode for watches that use these.
Troubleshooting:
Sometimes it takes a little while to install new watch faces over a slow Bluetooth connection. Wait at least a few minutes after installing on phone, by then watch face should be installed on the watch as well. Try reinstalling or re-syncing all apps to the watch if it still fails. This unfortunately affects all third party watch faces on Android Wear.
Sources are available at:
https://github.com/FruitieX/ArcWatch
Suggestions and feature requests are welcome!
时尚和简约的表盘为Android Wear。表示小时和分钟指针作为不同长度的弧。长按表盘,点击小齿轮图标底部配置手表表面的颜色和切换12 / 24-小时模式。
表盘同时支持烧机保护和低比特模式为使用这些手表。
故障排除:
有时需要一点时间来安装新表将面临的一个缓慢的蓝牙连接。至少等待几分钟,安装在手机上后,再由面看应安装在手表也是如此。请尝试重新安装或重新同步所有应用程序的手表,如果它仍然失败。这不幸的影响Android Wear所有第三方手表的面孔。
来源可在:
https://github.com/FruitieX/ArcWatch
建议和功能要求的欢迎!